This training course is for all who want to learn about the AGI and its many possibilities. The course aims to give the participant knowledge about both the AGI hardware and the AGI software pack.
This training course is for all who want to learn about the AGI and its many possibilities. The course aims to give the participant knowledge about both the AGI hardware and the AGI software pack.
This one-day training course is within Danish working hours 8.30 am to 4.00 pm
Course prerequisites
The AGI training is for everyone and does not require any prior training. Most important is that you are motivated to learn, but general knowledge of the industry is an advantage. Please note that the training will be conducted in English.
In the event of cancellation up to 14 days prior – no charge will be made. If cancellation is made after this time then an administration fee of 250 EUR per person will apply. DEIF reserves the right to cancel a training course with 2 weeks’ notice if the number of participants is insufficient.
Agenda
Day 1 08:30 - 08:45 Introduction of attendees 08:45 - 09:15 Introduction to AGI 400 09:15 - 09:30 Break 09:30 - 10:45 Introduction to AGI SW pack 10:45 - 11:45 AGI Creator assignments part 1 11:45 - 12:30 Lunch 12:30 - 14:00 AGI Creator assignments part 2 14:00 - 14:15 Break 14:15 - 15:45 Free play 15:45 - 16:00 Evaluation
Training is a cornerstone to success
With the rapid advances in generator control and the increasingly sophisticated communication between engines themselves, it has become more necessary than ever for operators and service personnel to receive hands-on training.
DEIF commits to providing our customers with the information and resources necessary for the efficient use of our products. To that end, we offer training sessions for you and your associates to help you learn how to use DEIF generator controllers and software appropriately on our simulation equipment around the world. Attending a DEIF training session will enable you to provide your customers with cost-efficient solutions that meet all common requirements.
We believe in learning by doing. Thus our courses involve hands-on training with simulation and emulation equipment in a clean, hazard-free, and controlled environment. Together we will simulate and troubleshoot a wide range of typical fault conditions and also applications based on input from the course participants without risking damage to your plant. The sessions are carried out in small groups for greater flexibility and more involvement.
Travelling to Skive
DEIF A/S is located in Skive, a 30 minute drive from Karup Airport, and 10 minutes’ drive from the below hotels. We will be happy to assist with hotel reservations. If you choose to make your own reservation, please refer to DEIF to obtain the below corporate rates.
Hotel Strandtangen Located at the harbour Reservations: (+45) 9676 0800
Hotel Gl. Skivehus Located in the center of Skive Reservations: (+45) 9752 1144
